無料デモをご利用いただけます
人々は信頼性が高く、プロフェッショナルな知識を持っている人は高給とジョブプロモーションを享受できるとよく考えられます。同時に、この分野の関連認定はあなたの専業知識の直接な反映です。弊社は簡単な方法であなたは試験に合格しながら対応認定を取られて助けるのを目指しています。百聞は一見にしかず、あなたは明らかに製品を了解するために、弊社はGB0-372-ENU試験ガイド資料の無料デモを提供します。ウエブサイトでの無料デモを使用した後、あなたは私達のGB0-372-ENU問題集参考書は国際市場にベストセラーになる原因を分かります。我々はずっと信じられます。
H3C分野で関連認定は、労働者の能力の証拠(GB0-372-ENU問題集参考書)として見なされることとよく考えられます。多くの雇用者は、特に大手会社の採用者が認定書の有無を重視する嫌いがあります。しかし、重要な認定証を取得する前に、H3C GB0-372-ENU試験に合格するのは必要です。これは、この分野の大多数の人にとって本当苦しいです。今に弊社はあなたがこの困難を克服するのを助けることを目指しています。我々のGB0-372-ENU練習問題は、この分野での試験のための最高の学習資料です、私たちはできるだけ、あなたが試験に合格し、関連する認定を得るのを手伝います。我々のGB0-372-ENU試験ガイド資料のメリットは以下の通りです。
最高品質のサービス
弊社はGB0-372-ENU問題集参考書の質量を高めることに10年以上従事してきたといっても過言ではありません。この分野のすべての人を助けるには、弊社の一流専門家は多くの異なる国々から、GB0-372-ENU練習問題の質を改善するための知恵と長所を奉げて集まるばかりです。さらに、我々は大衆の需要を注目し、すべての有用なアドバイスを聞いて、良い事をできるのを知っているから、顧客からのGB0-372-ENU試験ガイドに関する意見を非常に重視します。これは弊社はGB0-372-ENU問題集参考書の高品質を維持する強いツールです。あなたは回り道をしていない限り、我々の高い合格率試験資料を取り逃していけません。
一年の無料アップデット
時々に、お客様はGB0-372-ENU練習問題を購入することがありますが、すぐに受験しません。我々はこの状況に期限を定めます。既成の事実として、様々な学習資料は時代を追うために常に更新する必要があります。もし我々のGB0-372-ENU試験学習資料を選んでいるなら、一年を通して更新サービスを享受できます。H3C試験に参加する受験者にとって本当の良いニュースです。良い機会を逃さないでください!
GB0-372-ENU試験問題集をすぐにダウンロード:成功に支払ってから、我々のシステムは自動的にメールであなたの購入した商品をあなたのメールアドレスにお送りいたします。(12時間以内で届かないなら、我々を連絡してください。Note:ゴミ箱の検査を忘れないでください。)
H3CSE-RS-SW 認定 GB0-372-ENU 試験問題:
1. After executing the displayinterface Ethernet 1/0/1 command on the switch SWA, the output information is as follows:
[SWA] display interface Ethernet 1/0/1
Ethernet1/0/1 current state: UP
PVID: 10
Mdi type: auto
Link delay is 0 (sec)
Port link-type: trunk
VLAN passing: 1 (default vlan), 10
VLAN permitted: 1 (default vlan), 2-4094
Trunk port encapsulation: IEEE 802.1q
Port priority: 0
what can we learn from the above information? (Multiple choice)
A) Data with VLAN1 tag will not be stripped when it leaves port Ethernet1/0/1.
B) Port Ethernet1/0/1 is a Trunk port, allowing data frames from any VLAN to pass through.
C) When a data frame without a VLAN tag enters port Ethernet1/0/1, it will be tagged with VLAN1.
D) Port Ethernet1/0/1 is a Trunk port that only allows data from VLAN 1 and VLAN 10 to pass through.
2. As shown in the figure, there is no connection between SWA and SWB at the beginning. SWA and SWB enable RSTP. When the topology is stable, the ports connecting SWA and SWB assume that SWA will become the new root bridge. Which of the following statements are correct? (Multiple choice)

A) During the P/A process, no timer will be used, so the designated port can quickly enter the forwarding state, thereby achieving rapid network convergence.
B) After receiving the Agreement message sent by SWB, SWA's port E1/0/1 will immediately enter the forwarding state.
C) After SWB completes the synchronization process, it will reply with an Agreement message to SWA, and its port E1/0/1 will immediately enter the forwarding state.
D) The designated port of SWB will continue the P/A handshake process with the downstream switch
3. A customer purchased a router . If the performance indicators of this router are MTBF>Y14 8 years and MTTR<U1, then which of the following is the reliability of this router?
A) 99.9%
B) 99.9999%
C) 99.99%
D) 99.999%
4. The Output action defined by the OpenFlow protocol can forward packets to a specified port. Which of the following options are ports supported by Output? (Multiple choice)
A) FLOOD
B) SWITCH
C) NORMAL
D) CONTROLLER
5. The IP address of host PCA is 40.1.1.1, and the MAC address is 0011.1111.1111. PCA is connected to [SWA] vlan 10 of switch SWA.
[SWA-vlan10] quit
[SWA] vlan 20
[SWA-vlan20] protocol-vlan ipv4
[SWA-vlan20] quit
[SWA] vlan 30
[SWA-vlan30] quit
[SWA] mac-vlan mac-address 0011-1111-1111 vlan 30
[SWA] vlan 40
[SWA-vlan40] ip-subnet-vlan ip 40.1.1.0 255.255.255.0
[SWA-vlan40] quit
[SWA] interface GigabitEthernet 1/0/1
[SWA-GigabitEthernet1/0/1] port link-type hybrid
[SWA-GigabitEthernet1/0/1] port hybrid pvid vlan 10
[SWA-GigabitEthernet1/0/1] port hybrid vlan 10 20 30 40 untagged
[SWA-GigabitEthernet1/0/1] port hybrid protocol-vlan vlan 20 0
[SWA-GigabitEthernet1/0/1] port hybrid ip-subnet-vlan vlan 40
[SWA-GigabitEthernet1/0/1] mac-vlan enable
[SWA-GigabitEthernet1/0/1] vlan precedence ip-subnet-vlan
After the configuration is completed, which of the following can be determined that PCA will join?
A) VLAN20
B) VLAN 10
C) VLAN40
E The configuration command is incorrect.
D) VLAN30
質問と回答:
質問 # 1 正解: A、B | 質問 # 2 正解: A、B、C、D | 質問 # 3 正解: D | 質問 # 4 正解: A、C、D | 質問 # 5 正解: C |